Search published articles


Showing 2 results for Irom

A. Jafari Tadi, S.r. Hosseini, M. Naderi Semiromi,
Volume 14, Issue 3 (September 2017)
Abstract

Influence of formation of surface nano/ultrafine structure using deep rolling on plasma nitriding and tribological properties of the AISI 316L stainless steel was investigated. Initially, the deep rolling process was carried out on the bar-shaped specimens at 15 cycles with 0.2 mm/s longitudinal rate and 22.4 rpm bar rotation. Then, plasma nitriding treatment was applied on the as-received and deep rolled kinds at 450 °C and H2-25% Vol. N2 gas mixture for 5­ h. Surface micro-hardness and un-lubricated pin-on-ring sliding wear tests were carried out on the as-received, deep rolled, plasma nitrided and deep rolled-plasma nitrided kinds. Results revealed that deep rolled-plasma nitrided kind is shown the highest wear resistance than the others, due to the further increased surface hardness achieved via the combined process.


S.m. Moussavi Janbesarayi, M. Mohebi, S. Baghshahi, S.a. Ahmad Alem, E. Irom,
Volume 17, Issue 2 (June 2020)
Abstract

Overusing nitrogen fertilizer causes some serious problems for water resources, soil, and agriculture products. Researchers have been trying to develop effective means which may use less amount of fertilizers containing nitrogen. In this work, cost-effective ceramic granule adsorbent was prepared to be used as a fertilizer carrier of controlled release behavior. A mixture of 70 wt.% domestic kaolin and 30 wt.% gibbsite was used to produce the granules. By utilizing thermal analysis of raw granule, the calcination temperatures were obtained and the effect of various calcination temperatures of 500, 600, and 700˚C on the water adsorption was studied. The characteristics of granules were investigated by XRD, BET, FTIR, and SEM analyses. The results showed that by increasing the calcination temperature, the crystal structure of the granules was transformed into a dehydrated form and by calcination at 600°C the specific surface area of granules increased from 7.50 to 53.45m2/g. The granules were soaked in a 500g/lit solution of urea, where they adsorbed about 10wt.% urea. The dried urea-loaded granules were placed in water where the release of urea was measured by UV-vis spectrophotometry. Finally, different portions of urea-loaded granules were evaluated as fertilizer in the growing bed of corn plant where the height and the stem diameter of samples were compared with a control sample as well as a sample fertilized by urea directly. The results showed that by using the loaded granules, the urea consumption can be reduced by 50%.
 


Page 1 from 1     

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb