Showing 3 results for Current Density
A. M. Behagh, A. Fadaei Tehrani, H. R. Salimi Jazi, O. Behagh,
Volume 12, Issue 1 (3-2015)
Abstract
n this paper a finite element model has been proposed for evaluation of primary and secondary current
density values on the cathode surface in nickel electroplating operation of a revolving part. In addition, the capability
of presented electroplating simulation has been investigated in order to describe the electroplated thickness of the
nickel sulfate solution. Nickel electroplating experiments have been carried out. A good agreement between the
simulated and experimental results was found. Also the results showed that primary current density can describe the
general form of thickness distribution but the relative value of current density using secondary current density can
present better description of thickness distribution
Z. Ghaferi, S. Sharafi, M.e. Bahrololoom,
Volume 14, Issue 2 (6-2017)
Abstract
In this research, nanocrystalline Co-Fe coatings were electrodeposited on copper substrate. The influence of current density on different properties of the films at two pH levels was investigated. All the coatings showed nodular structure with rougher morphology at higher current densities. Due to anomalous deposition at higher current density, the amount of iron content increased and reached its maximum value at about 50 wt.% for the coating obtained from pH 5. X-ray diffraction patterns showed hcp structure as the dominant phase. However, by increasing current density at lower pH value, a double phase structure containing fcc+hcp phases was detected. It was observed that current density has a positive effect on grain refinement. However, coarser grains would obtain at lower pH value. Microhardness measurements showed that, there is a direct relationship between grain size and microhardness. Moreover, microstructure in double phase structure films can influence microhardness more dominantly. Vibrating sample magnetometer (VSM) measurements indicated that the saturation magnetic is proportion to deposited iron content and reached its maximum value at about 1512 emu/cm3. It was cleared that grain size, phase structure and chemical composition can affect coercivity of the films effectively.
H. Mohebbi, S.m. Mirkazemi,
Volume 17, Issue 4 (12-2020)
Abstract
Flash sintering of 8 mol% yttria-stabilized zirconia (8YSZ) as solid oxide fuel cell (SOFC) electrolyte is studied. The relation between relative density, shrinkage, sample temperature during the flash, and incubation time, with the electric field strength, current density, as well as contact paste, are modeled by response surface methodology (RSM). The electric field strength and current density varied from 50 to 400V.cm-1 and 50 to 200mA.mm-2, respectively. Also, platinum (Pt) and lanthanum strontium manganite (LSM) used as contact paste. Results show that using LSM paste lead to higher density and more shrinkage compare with Pt paste. Contrary, the electric field strength has no significant effect on density and shrinkage. However, a minimum electric field strength equal to 80 V.cm-1 is necessary for flash onset. As the field increases, the incubation time decreases dramatically. Compare with samples with LSM paste, samples with Pt contact paste reach to a higher temperature during the flash. Flash sintered 8YSZ shows the mean grain size of 0.3μm, which is about half of the conventionally sintered 8YSZ. Electrochemical Impedance Spectroscopy reveals despite lower mean grain size, the resistivity of flash sintered 8YSZ is lower than conventionally sintered 8YSZ.
